• Designed for use with R22, R404A, R507 and R407C.
• Energy efficient compressors with POE. Several Options to choose from: Copeland Discus, Bitzer reciprocating.
• Single, Dual and parallel-piped(optional) compressor configurations available.
• ThermospanTM condenser core design eliminates tube sheet leaks and provides reliable operation.
• 3/8" condenser tubes reduces refrigerant charge.
• Generously sized condenser allows unit to operate at higher than normal ambient conditions.
• Optional coating and fin surfaces for condenser core protection available.
• Receivers (where used) are liberally sized and include inlet as well as outlet service valves.
• Subcooling circuit in condenser on all models (except high temperature H8 models) increases overall system efficiency and provides dependable compressor operation.
• Utilizes pre-formed internal piping, eliminates welded joints and reduces chances of a leak.
• Electrical components are housed in a spacious and conveniently located panel. In case of a compressor trip, (except on air conditioning models) a Lock-out relay de-energizes the liquid line solenoid valve. In addition, SPDT contact is provided for field wired alarm circuit.
• End compartment panels allow unrestricted access to service the compressor(s) and all other components.
• Units are available with energy efficient Thermosaver™ hot gas defrost option.
• Units are environmently friendly operating on less power and refrigerant charge.

Standard Features include:

• Spring mount compressor with discharge and suction vibration eliminator.
• Compressor head cooling fans on low temperature models
• Compressor crankcase heater
• Flexible hose on all compressor pressure control connections
• Two valve adjustable (pre-set at factory) Low Ambient head pressure control.
• Condenser fan cycling control (pressure) on two-fan models.
• Fused condenser fan motors
• Receiver inlet/outlet valves and safety pressure relief valve
• Replaceable liquid line drier & sight glass
• Anti-short cycle time delay relay
• Oil failure control (non-electronic)
• Separate HP and LP compressor controls.
• Lock out relay.
• Sub-cooling circuit on medium and low temperature units.

Factory installed

Optional Features

• Suction accumulator (with or without heat exchanger)
• Replaceable suction filter
• Insulated suction lines.
• Crankcase Pressure Regulating valve
• Compressor capacity control available where applicable
• Discharge line check valve
• Hot gas bypass tees / regulating valves / de-superheating TXV
• Oil separator
• Oversized condenser (except largest unit)
• Oversized receiver
• Heated and insulated receiver
• Thermosaver™ defrost.
• Disconnect switch (fused or non-fused).
• Electronic Oil failure control
• Voltage / Phase monitor
• Defrost Time clock
• Defrost Heater / Evaporator Fan Contactors with fuse block
• Single point electrical service hook up for evaporator and controls
• Discharge line thermostat

• Models include sealed liquid line filter drier and sight glass