A/C, Single Phase, Split Gas Furnace Single Stage, Multi Position "A" Coil H4A6S/N96VSN/EAM4X
Air Conditioner Condenser
80% AFUE
Flame roll-out sensors standard
Category I venting
Blocked vent switch
Louvered door
24 VAC and 115 VAC humidifier terminal
Electronic air cleaner terminal
Select sizes approved for twinning, refer to accessory kit listing
N80ESL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
Adjustable heating blower OFF delay
Factory set blower ON delay
RPJ aluminized steel heat exchanger
High temperature limit control designed to prevent overheating
Direct ignition with Silicon Nitride igniter
One piece prepainted steel cabinet
In-shot burners
33 1/3” (847mm) high, for ease of installation
Quarter turn knobs for easy door removal and secure attachment
Factory shipped for natural gas, convertible to propane with accessory kit
Four position - upflow/downflow/horizontal (left/right) installation
Three position inducer elbow capability
Through the casing flue pipe for counterflow applications
Common venting with other Category I appliances
Masonry chimney adapter available
Self diagnostics
Slide out blower assembly
Gas Furnace
Fully insulated steel cabinet
Dehumidification feature in cooling
Certified to leak 2% or less of nominal air conditioning CFM delivered (when pressured to 1 inch water column with all present air inlets, air outlets, and condensate drain port(s) sealed
VCT Constant Torque Variable Speed Motor
Supports Single & Two Stage A/C
Aluminized steel RPJ primary heat exchanger
Stainless Steel Secondary Heat Exchanger
Direct ignition with Silicon Nitride ignitor
Direct vent (2-pipe), single-pipe venting, or ventilated combustion air
35” (889mm) high, for ease of installation
Four position - upflow/downflow/horizontal (left/right) installation
At least twelve different venting configurations
Through the casing flue pipe for counterflow or horizontal applications with accessory (order separately)
Self diagnostics with super bright LED
Concentric vent available
Twining capable (select sizes) w/ kit
Evaporator Coil
Corrosion resistant aluminum tube
Bolt-on TXV metering device factory installed on all models (equalizer tube brazed in)
TXV and manifold positioned to the side for easier cleaning
Innovative drain pan design for complete water removal
Two condensate drain connections (Additional two for horizontal installation)
2-piece delta plate for easier removal and cleaning
Cabinet widths match flush with Arcoaire gas furnaces
Hemmed flanges for safer handling
Foil faced insulation
Non-sweat cabinet, even at extreme conditions
Cabinets meet or exceed 2% air leakage codes
Sturdy, 22 gauge, pre-painted steel cabinet
One or two UV light knock-outs provided on cabinet (depending on size)