A/C, Single Phase, Split Gas Furnace Single Stage, Horizontal Slab H4A6S/F96VTN/EHD4X
Air Conditioner Condenser
80% AFUE
Flame roll-out sensors standard
Category I venting
Blocked vent switch
Louvered door
24 VAC and 115 VAC humidifier terminal
Electronic air cleaner terminal
Select sizes approved for twinning, refer to accessory kit listing
N80ESL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
Adjustable heating blower OFF delay
Factory set blower ON delay
RPJ aluminized steel heat exchanger
High temperature limit control designed to prevent overheating
Direct ignition with Silicon Nitride igniter
One piece prepainted steel cabinet
In-shot burners
33 1/3” (847mm) high, for ease of installation
Quarter turn knobs for easy door removal and secure attachment
Factory shipped for natural gas, convertible to propane with accessory kit
Four position - upflow/downflow/horizontal (left/right) installation
Three position inducer elbow capability
Through the casing flue pipe for counterflow applications
Common venting with other Category I appliances
Masonry chimney adapter available
Self diagnostics
Slide out blower assembly
Gas Furnace
Two-stage heating operation
Two-speed induced draft combustion blower
Supports single- and two-stage cooling units
Dehumidification feature (A/C)
Fully insulated steel cabinet
Certified to leak 2% or less of nominal air conditioning CFM delivered (when pressurized to 1 inch water column with all present air inlets, air outlets, and condensate drain port(s) sealed)
VCT Variable Speed Constant Torque Motor
Aluminized steel RPJ primary heat exchanger
Stainless steel secondary heat exchanger
Direct ignition with Silicon Nitride ignitor
Direct vent (2-pipe), single-pipe venting, or ventilated combustion air
35” (889mm) high , for ease of installation
Four position - upflow/downflow/horizontal (left/right) installation
At least twelve different venting configurations
Through the casing flue pipe for counterflow or horizontal applications with accessory (order separately)
Self-configuring and communicating control
Concentric vent available
Twining Capable (select size) w/ kit
Evaporator Coil
Thermostatic Expansion Valve (TXV)
Horizontal bi-directional airflow design
Sturdy galvanized steel cabinet
Non-ozone-depleting R-410A refrigerant
Capacity: 2 - 5 tons
Cased horizontal slab coil design for bi-directional airflow
Corrosion-resistant all-aluminum coil
Fully insulated cabinet
Corrosion-free sloped drain pan design helps reduce mold and bacterial buildup